Insert Swage Stud System For Timber Posts

$10.44
Ex Tax: $9.49
  • Product Code: Kit-INSS
  • Availability: 2-3 days

OverView

Insert Swage Stud System For Timber PostsThe Insert Swage Stud System is one of our most popular balustrade systems for timber posts.  Its streamline finish and simple installation made is prefect for the DIY handyman o...

Package contains

Swage Stud suits 3.2mm wire M6 x 35mm LHT Swage Stud suits 3.2mm wire M6 x 35mm LHT $2.59 x 1
Swage Stud suits 3.2mm wire M6 x 35mm RHT Swage Stud suits 3.2mm wire M6 x 35mm RHT $2.46 x 1
Threaded Insert M6 x 32mm LHT ProRig AISI 304 Threaded Insert M6 x 32mm LHT ProRig AISI 304 $2.70 x 1
Threaded Insert M6 x 32mm RHT ProRig AISI 304 Threaded Insert M6 x 32mm RHT ProRig AISI 304 $2.70 x 1
Factory Hydraulic Swaging Factory Hydraulic Swaging $2.75 x 2

Available Options

Below are optional accessories that are suitable for use with this product

If you would like any of these accessories, enter desired quantities here, then click ADD TO CART button below

  • Grand total (including added accessories):

  • Grand total (Ex Tax):

Insert Swage Stud System For Timber Posts

The Insert Swage Stud System is one of our most popular balustrade systems for timber posts.  Its streamline finish and simple installation made is prefect for the DIY handyman or the experienced home or deck builder.

This system requires that the fittings be hydraulically swaged to the wires, which our in-house fabrication department can provide.

SYSTEM ITEMS: 

1 X M6 Threaded insert RHT

1 x M6 Threaded insert LHT

1 x M6 Swage stud RHT

1 x M6 Swage stud LHT


PLEASE ADD THE TOTAL LINEAL METRES OF WIRE REQUIRED IN THE ACCESSORIES AREA ABOVE.  

IF YOU REQUIRE ENDS AND FITTINGS TO BE SWAGE PLEASE INCLUDE FACTORY SWAGING FOR EACH OF THE WIRE ABOVE.

ALSO INCLUDE YOUR INSIDE POST TO INSIDE POST MEASUREMENTS ABOVE.


Need help? Use our online balustrade builder calculator.  Watch instructional video in Related Videos tab to the left.


How To Install Balustrade System 

After providing Miami Stainless with your inside to inside post measurements (picture) and receiving your hydraulically swaged wires, you can begin by pre-drilling  7.5mm holes into your end and intermediate posts. To learn how to make a template for drilling holes visit the resource section at miamistainless.com.au.


Use a 6mm hex drive bit to screw in the threaded inserts ensuring left hand inserts are in the left hand post and right hand inserts are in the right hand post. 

Insert the right hand swage stud into the right hand threaded insert just enough for it to hold. Pass the opposite end of the wire through any intermediate posts and repeat with the left hand post.



Tension both ends of the wire evenly using a ProRig c-spanner then lock in place by tightening the hex nut. 

Repeat until all of your sections are complete.




To view our how to video or find out more about this product view our dedicated Insert Swage Stud System page.


hiii

How to use the balustrade builder calculator