Our Tensioner Swage Stud with Flip Toggle System is a popular streamline stainless steel wire balustrade system that utilises flip toggle instead of a rod terminal. Available to suit both timber and metal posts, the Tensioner Swage Stud System with Flip Toggle is perfect for single straight or stair sections. Please Note: It is not recommended this system be used where corners exist unless the intersecting wires are offset.
To install the Tensioner Swage Stud System with Flip Toggle, pre-drill holes in posts, for flip toggle end drill a 6mm hole in the inside face only and a 9mm hole for the hex head tensioner on both sides of opposide end post. Intermediate posts require a 7.5mm hole. Insert the flip toggle end of the 6mm hole and pull the wire to lock in place. Pass the opposite end of the wire through any intermediate posts and thread into hex head tensioner inside of end post. Use a spanner and 1/4″ allen key to tension wires and lock system into place.
To order, simply measure the outside distance between the starting and finishing points of your posts and provide them to Miami Stainless either through our online Balustrade Builder or contact us directly via phone, fax or email. Your wires will arrive to your door pre-swaged to your exact measurements for a very quick and simple installation.
Please Note: This method is suitable for both timber and metal posts. It is recommended that you use a standard flat washer on each outside face of your posts when installing this system with timber posts.
Read FAQ and learn more about the Tensioner Swage Stud System here.
Thousands of products from the highest quality stainless steel and hardware manufacturers.
